Neighbor - Dell Z9500 Command Reference Manual

neighbor

Define a neighbor router with which to exchange RIP information.
Z9500
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
ip-address
Defaults Not configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
Usage
When a neighbor router is identified, unicast data exchanges occur. Multiple
Information
neighbor routers are possible.
To ensure that only specific interfaces are receiving and sending data, use the
passive-interface command with the neighbor command.
Related passive-interface
Commands
1546
Enter the IP address, in dotted decimal format, of a router
with which to exchange information.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— sets the interface to only listen to RIP broadcasts.
Routing Information Protocol (RIP)