Port-Channel-Protocol Lacp - Dell Z9500 Command Reference Manual

Mode
passive
off

port-channel-protocol lacp

Enable LACP on any LAN port.
Z9500
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp
command.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
6.2.1.1
Related
show lacp
Commands
show interfaces port-channel
groups.
1134
Function
automatically initiates negotiation with other ports by
initiating LACP packets.
An interface is not in an active negotiating state in this
mode. LACP runs on any link configured in the passive state.
Ports in a passive state respond to negotiation requests from
other ports that are in active states. Ports in a passive state
respond to LACP packets
An interface cannot be part of a dynamic port channel in off
mode. LACP does not run on a port configured in off mode.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
— displays the LACP information.
— displays information on configured Port Channel
Link Aggregation Control Protocol (LACP)