Dell Z9500 Command Reference Manual page 1225

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
7.5.1.0
6.2.1.1
Usage
The connect-source option is used to supply a source IP address for the TCP
Information
connection. When an interface is specified using the connect-source option, the
primary configured address on the interface is used.
If the total number of SA messages received from the peer is already larger than the
limit when this command is applied, those SA messages continue to be accepted.
To enforce the limit in such situation, use the clear ip msdp peer command to
reset the peer.
Related
ip msdp sa-limit
Commands
clear ip msdp peer
show ip msdp
Multicast Source Discovery Protocol (MSDP)
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Added option for SA upper limit and the description
option.
Introduced
— configures the MSDP SA Limit.
— clears the MSDP peer.
— displays the MSDP information.
1225