Ip Redirect-List - Dell Z9500 Command Reference Manual

Usage
You can apply any number of redirect-groups to an interface. A redirect list can
Information
contain any number of configured rules. These rules includes the next-hop IP
address where the incoming traffic is to be redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop.
Otherwise, the normal routing table is used to forward traffic. When a redirect-
group is applied to an interface and the next-hop is reachable, the rules are added
into the PBR CAM region. When incoming traffic hits an entry in the CAM, the
traffic is redirected to the corresponding next-hop IP address specified in the rule.
Related
•
Commands
•

ip redirect-list

Configure a redirect list and enter REDIRECT-LIST mode.
Z9500
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
Parameters
redirect-list-
name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.4(0.0)
8.4.2.1
8.4.2.0
Policy-based Routing (PBR)
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
show cam pbr – displays the content of the PBR CAM.
show ip redirect-list – displays the redirect-list configuration.
Enter the name of a redirect list.
Description
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, and Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
1425