Ip Msdp Sa-Filter - Dell Z9500 Command Reference Manual

ip msdp sa-filter

Permit or deny MSDP source active (SA) messages based on multicast source and/or group from the
specified peer.
Z9500
Syntax
ip msdp sa-filter {in | out} peer-address list [access-list
name]
Remove this configuration using the no ip msdp sa-filter {in | out}
peer address list [access-list name] command.
Parameters
in
out
peer-address
access-list
name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
Multicast Source Discovery Protocol (MSDP)
Enter the keyword in to enable incoming SA filtering.
Enter the keyword out to enable outgoing SA filtering.
Enter the peer address of the MSDP peer in a dotted decimal
format (A.B.C.D.).
Enter the name of an extended ACL that contains permitted
SAs. If you do not use this option, all local entries are
blocked.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
1227