Dell Z9500 Command Reference Manual page 1431

operator
source port
destination-
port
source-port-
range
destination-
port-range
Defaults none
Command REDIRECT-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.4(0.0)
Policy-based Routing (PBR)
(OPTIONAL) For the TCP and UDP parameters only. Enter
one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two
ports for the port command parameter.)
Enter the keywords source-port then the port number to
be matched in the ACL rule in the ICAP rule
Enter the keywords destination-port then the port
number to be matched in the ACL rule in the ICAP rule.
Enter the keywords Source-port-range then the range of
the start port to end port to be matched in the ACL rule in
the ICAP rule.
Enter the keywords destination-port-range then the
range of the start port to end port to be matched in the ACL
rule in the ICAP rule.
Description
Added the keyword track-id on the Z9500.
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, and Z9000.
1431