Peer-Link Port-Channel - Dell Z9500 Command Reference Manual

Command VLT DOMAIN (conf-vlt-domain)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.2(0.0)
9.2(0.2)
9.0.2.0

peer-link port-channel

Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.
Syntax
peer-link port-channel port-channel-number {peer-down-vlan vlan
id}
Parameters
port-channel-
number
peer-down-
vlan vlan id
Defaults Not configured.
Command VLT DOMAIN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
1856
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the Z9000, S4810, and S4820T.
Introduced on the S6000.
Enter the port-channel number that acts as the interconnect
trunk. The range is from 1 to 512.
Enter the keyword peer-down-vlan then a VLAN ID to
configure the VLAN that the VLT peer link uses when the VLT
peer is down.
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Virtual Link Trunking (VLT)