Show Logging Auditlog - Dell Z9500 Command Reference Manual

Example
Dell#show logging history
(History)
Syslog History Table: 1 maximum table entries,
saving level warnings or higher
SNMP notifications not Enabled
Feb 18 01:16:57: %SYSTEM:CP %SEC-3-
AUTHENTICATION_ENABLE_SUCCESS: Enable password authentication
success on vty0 ( 10.16.127.145 )

show logging auditlog

Displays an audit log.
Syntax
show logging auditlog
Defaults none
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.5(0.0)
Example
Dell(conf)#show logging audit
Related clear logging auditlog
Commands
show logging driverlog
Display the driver log for the specified hardware component.
Z9500
Syntax
show logging driverlog {cp | rp | linecard slot-id}
Parameters
cp
rp
1748
Description
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
— clears audit log.
Enter the keyword cp to display the driver log for the Control
Processor on the switch.
Enter the keyword cp to display the driver log for the Route
Processor on the switch.
Simple Network Management Protocol (SNMP) and Syslog