Router Isis - Dell Z9500 Command Reference Manual

Version
8.3.19.0
8.3.11.1
8.3.12.0
7.5.1.0
6.3.1.0
Usage How a metric value assigned to a redistributed route is advertised depends on how
Information on the configuration of the metric-style command. If the metric-style
command is set for Narrow mode and the metric value in the redistribute
ospf command is set to a number higher than 63, the metric value advertised in
LSPs is 63. If the metric-style command is set for wide mode, the metric value
in the redistribute ospf command is advertised.

router isis

Allows you to enable the IS-IS routing protocol and to specify an IP IS-IS process.
Z9500
Syntax
router isis [vrf vrf-name] [tag]
To disable IS-IS routing, use the no router isis [tag] command.
Parameters
vrf vrf-name
tag
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Intermediate System to Intermediate System (IS-IS)
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for IPv6 ISIS.
Introduced.
Enter the keyword vrf followed by the name of the VRF to
enable the IS-IS routing protocol and to specify an IP IS-IS
process on that VRF.
(OPTIONAL) This is a unique name for a routing process. A
null tag is assumed if the tag option is not specified. The tag
name must be unique for all IP router processes for a given
router.
1111