Ntp Master <Stratum - Dell Z9500 Command Reference Manual

Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.4.1.0
8.3.7.0
6.1.1.0
ntp master <stratum>
Configure the switch as NTP Server.
Syntax
ntp master <stratum>
Parameters
ntp
master<stratum
>
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
1794
• 224.0.1.1 is configured if the interface address is IPv4
• ff05::101 is configured if the interface address is IPv6
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for IPv6 multicast addresses.
Introduced on the S4810.
Introduced on the E-Series.
Enter the stratum number to identify the NTP Server's
hierarchy.
Description
Introduced on the S6000-ON.
System Time and Date