Interface - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

show interfaces

interface

Configure a physical interface on the switch.

interface interface range

Not configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

— displays the negotiated flow control parameters.

Enter one of the following keywords and slot/port or number

information:

For a null interface, enter the keyword null then the

slot/port information. The Null interface number is 0.

For a Management Ethernet interface, enter the keyword

managementethernet then the slot/port information.

For a Loopback interface, enter the keyword loopback

then the slot/port information. The range is from 0 to

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a Tunnel interface, enter the keyword tunnel then

the tunnel ID. The range is from 1 to 16383.

For a VLAN interface, enter the keyword vlan then the

slot/port information. The range is from 1 to 4094.

(Optional) Enter the keyword range to configure an

interface range.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.