Show Ip Igmp Snooping Groups - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

INTERFACE VLAN — (conf-if-vl-n)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

This command enables the IGMP switch to send General Queries periodically. This

behavior is useful when there is no multicast router present in the VLAN because

the multicast traffic is not routed. Assign an IP address to the VLAN interface for the

switch to act as a querier for this VLAN.

show ip igmp snooping groups

Display snooping related information for all the IGMP groups, interface or one group of one interface.

show ip igmp snooping groups [group-address [detail] | detail |

interface [group-address [detail]]]

group-address

Introduced on the Z9500.

Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

(OPTIONAL) Enter the group address in dotted decimal

format to view information on that group only.

(OPTIONAL) Enter the interface type and slot/port

information:

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a port channel interface, enter the keywords port-

channel then a number.

Internet Group Management Protocol (IGMP)