Show Ip Mroute - Dell Force10 S4810P Reference Manual

Command Modes INTERFACE VLAN
Command History
Version 7.7.1.0
Usage
This command restricts flooding for all unknown multicast traffic on ports below a certain
Information
speed. If you want some multicast traffic to be flooded on slower ports, use the mac-flood-
list command without the min-speed option, in combination with restrict-flooding. With
mac-flood-list, you specify the traffic you want to be flooded using a MAC address
range.
You may not use the unicast MAC addresses when specifying MAC address ranges (do not
overlap MAC addresses ranges) when creating multiple mac-flood-list entries for the
same VLAN. Restricted Layer 2 flooding is not compatible with MAC accounting or VMANs.
Related mac-flood-list
Commands

show ip mroute

View the multicast routing table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip mroute [static | group-address [source-address] |
active [rate] | count | snooping [vlan vlan-id] [group-address
[source-address]] | summary]
Parameters
static
group-address
source-address ]
[
active [
count
snooping [vlan
vlan-id ] [ group-
address [ source-
address ]]
Introduced on the E-Series TeraScale.
– floods multicast frames with specified MAC addresses to all ports in a VLAN.
(OPTIONAL) Enter the keyword static to view static multicast
routes.
(OPTIONAL) Enter the multicast group-address to view only routes
associated with that group.
Enter the source-address to view routes with that group-address and
source-address.
rate ]
(OPTIONAL) Enter the keyword active to view only active multicast
routes. Enter a rate to view active routes over the specified rate. The
range is 0 to 10000000.
(OPTIONAL) Enter the keyword count to view the number of
multicast routes and packets on the E-Series.
(OPTIONAL) E-Series ExaScale and S4810 only:
Enter the keyword snooping to display information on the multicast
routes discovered by PIM-SM snooping.
Enter a VLAN ID to limit the information displayed to the multicast
routes discovered by PIM-SM snooping on a specified VLAN. the
valid VLAN ID range is 1 to 4094.
Enter a multicast group address and, optionally, a source multicast
address in dotted decimal format (A.B.C.D) to limit the information
displayed to the multicast routes discovered by PIM-SM snooping for
a specified multicast group and source.
1123