Show Ip Ospf Neighbor - Dell Force10 S4810P Reference Manual

Router)
Loopback 0 is up, line protocol is up
LOOPBACK, Cost: 1
Loopback interface is treated as a stub Host.
FTOS>

show ip ospf neighbor

Display the OSPF neighbors connected to the local router.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip ospf process-id neighbor
Parameters
process-id
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage The following describes the show ip ospf process-id neighbor command shown
Information
in the Example below.
Item
Neighbor ID
Pri
State
Dead Time
Address
Interface
Area
Hello due in 00:00:08
Neighbor Count is 3, Adjacent neighbor count is 2
Adjacent with neighbor 192.168.253.5 (Designated Router)
Adjacent with neighbor 192.168.253.3 (Backup Designated
Internet Address 192.168.253.2/32, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the neighbor router ID.
Displays the priority assigned neighbor.
Displays the OSPF state of the neighbor.
Displays the expected time until FTOS declares the neighbor dead.
Displays the IP address of the neighbor.
Displays the interface type slot/port information.
Displays the neighbor's area (process ID).
1199