Access-Class; Enable Password - Dell Force10 S4810P Reference Manual

access-class

Restrict incoming connections to a particular IP address in a defined IP access control list (ACL).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax access-class access-list-name
To delete a setting, use the no access-class command.
Parameters
access-list-name
Defaults Not configured.
Command Modes LINE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Related
line
Commands
ip access-list standard
address.
ip access-list extended
addresses or protocols.

enable password

Change the password for the enable command.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type]
password [level level] command.
Parameters
level
encryption-type
1414
Enter the name of an established IP Standard ACL.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– applies an authentication method list to the designated terminal lines.
– names (or selects) a standard access list to filter based on the IP
– names (or selects) an extended access list based on the IP
level
(OPTIONAL) Enter the keyword level followed by a number as the
level of access. The range is 1 to 15.
(OPTIONAL) Enter the number 7 or 0 as the encryption type.
Enter a 7 followed by a text string as the hidden password. The text
string must be a password that was already encrypted by a Dell
Force10 router.