Ipv4 Routing; Arp - Dell Force10 S4810P Reference Manual

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 S4810P:

Table of Contents

IPv4 Routing

The basic IPv4 commands are supported by FTOS on all Dell Force10 E-Series, C-Series, S-Series or Z-Series platforms.

Use address resolution protocol (ARP) to associate an IP address with a MAC address in the switch.

C-Series, E-Series, S-Series, Z-Series, S4810

arp vrf {vrf name} ip-address mac-address interface

To remove an ARP address, use the no arp ip-address command.

Not configured.

Command Modes

CONFIGURATION

E-Series Only: Enter the virtual routing and forwarding (VRF) process

identifier to tie the static route to the VRF process.

Enter an IP address in dotted decimal format.

Enter a MAC address in nnnn.nnnn.nnnn format.

(OPTIONAL) Enter any of the following keywords and slot/port or

number information:

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For the Management interface, enter the keyword

ManagementEthernet followed by the slot/port

information. The slot range is 0 to 1 and the port range is 0.

For a Port Channel interface, enter the keywords port-

channel followed by a number. For the C-Series and S-

Series, the range is 1 to 128. For the E-Series, the range is 1 to

255 for TeraScale and 1 to 512 for ExaScale.

For a SONET interface, enter the keyword sonet followed by

the slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by the slot/port information.