Show Ipv6 Cam Linecard - Dell Force10 S4810P Reference Manual

Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
Usage Because this command is enabled by default, it does not appear in the running configuration.
Information When you disable unicast routing, the no ipv6 unicast-routing command is included
in the running configuration. Whenever unicast routing is disabled or re-enabled, FTOS
generates a syslog message indicating the action.
Disabling unicast routing on an E-Series chassis causes the following behavior:

show ipv6 cam linecard

Displays the IPv6 CAM entries for the specified line card.
C-Series, E-Series
Syntax show ipv6 cam linecard slot-number port-set {0-1} [summary |
index | ipv6 address]
Parameters
slot-number
port-set
summary
index
ipv6-address
Defaults none
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
• static and protocol learnt routes are removed from RTM and from the CAM; packet
forwarding to these routes is terminated
• connected routes and resolved neighbors remain in the CAM and new IPv6 neighbors
are still discoverable
• additional protocol adjacencies (OSPFv3 and BGP4) are brought down and no new
adjacencies are formed
• the IPv6 address family configuration (under router bgp) is deleted
• IPv6 Multicast traffic continues to flow unhindered
Enter the line card slot ID number. The range is 0 to 13 on the E1200, 0
to 6 on the E600, and 0 to 5 on the E300.
Enter the keyword Port Set.
(OPTIONAL) Enter the keyword summary to display a table listing
network prefixes and the total number prefixes which can be entered
into the IPv6 CAM.
(OPTIONAL) Enter the index in the IPv6 CAM.
Enter the IPv6 address in the x:x:x:x::x/n format to display networks
that have more specific prefixes. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
945