Show Ip Rip Database - Dell Force10 S4810P Reference Manual

show ip rip database

Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip rip database [ip-address mask]
Parameters
ip-address
mask
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage The following describes the show ip rip database command shown in the Example
Information below.
Field
Total number of
routes in RIP
database
100.10.10.0/24
directly connected
150.100.0.0
redistributed
209.9.16.0/24...
Example
FTOS#show ip rip database
Total number of routes in RIP database: 1624
204.250.54.0/24
204.250.54.0/24
203.250.49.0/24
203.250.49.0/24
210.250.40.0/24
210.250.40.0/24
207.250.53.0/24
1372
(OPTIONAL) Specify an IP address in dotted decimal format to view
RIP information on that network only. If you enter an IP address, you
must also enter a mask for that IP address.
(OPTIONAL) Specify a mask, in /network format, for the IP address.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the number of RIP routes stored in the RIP database.
Lists the route(s) directly connected.
Lists the routes learned through redistribution.
Lists the routes and the sources advertising those routes.
[50/1] via 192.14.1.3, 00:00:12, GigabitEthernet 9/15
auto-summary
[50/1] via 192.13.1.3, 00:00:12, GigabitEthernet 9/14
auto-summary
[50/2] via 1.1.18.2, 00:00:14, Vlan 18
[50/2] via 1.1.130.2, 00:00:12, Port-channel 30
auto-summary