Mtrace - Dell Force10 S4810P Reference Manual

vlan
min-speed
speed
Defaults none
Command Modes CONFIGURATION
Command History
Version 7.7.1.0
Usage
When you use the mac-flood-list command with the min-speed option in combination
Information
with the restrict-flood command, the mac-flood-list command has higher priority
than the restrict-flood command.
Therefore, all multicast frames matching the mac-address range specified using the mac-
flood-list command are flooded according to the mac-flood-list command. Only
the multicast frames not matching the mac-address range specified using the mac-flood-
list command are flooded according to the restrict-flood command.
Related restrict-flooding
Commands specified speed.

mtrace

Trace a multicast route from the source to the receiver.
E-Series
Syntax mtrace {source-address/hostname} {destination-address/hostname}
{group-address}
Parameters
source-address/
hostname
destination-
address/
hostname
group-address
Command Modes EXEC Privilege
Command History
Version 7.5.1.0
Version 7.4.1.0
E-Series legacy
command
vlan-list
Enter the VLAN(s) in which flooding is restricted. Separate values by
commas — no spaces (1,2,3) or indicate a list of values separated by
a hyphen (1-3). The range is 1 to 4094.
min-
(OPTIONAL) Enter the minimum link speed that ports must have to
receive the specified flooded multicast traffic.
Introduced on the E-Series.
– prevents Layer 2 multicast traffic from being forwarded on ports below a
Enter the source IP address in dotted decimal format (A.B.C.D).
Enter the destination (receiver) IP address in dotted decimal format
(A.B.C.D).
Enter the multicast group address in dotted decimal format (A.B.C.D).
Expanded to support originator.
Expanded to support the intermediate (transit) router.
1121