Protocol Spanning-Tree Pvst - Dell Force10 S4810P Reference Manual

Bridge ID Priority 32773 (priority 32768 sys-id-ext 5),
Address 0001.e832.73f7
We are the root of Vlan 5
Configured hello time 2, max age 20, forward delay 15
Interface Designated
Name
-------------------------------------------------------------
Gi 0/10 128.140 128
128.140
Gi 0/12 128.142 128
128.142
Interface
Name
--------------------------------------------------------
Gi 0/10
Gi 0/12
Related

protocol spanning-tree pvst

Commands
protocol spanning-tree pvst
Enter the PVST+ mode to enable PVST+ on a device.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax protocol spanning-tree pvst
To disable PVST+, use the disable command.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 8.3.1.0
Example
FTOS#conf
FTOS(conf)#protocol spanning-tree pvst
FTOS(conf-pvst)#no disable
FTOS(conf-pvst)#vlan 2 bridge-priority 4096
FTOS(conf-pvst)#vlan 3 bridge-priority 16384
FTOS(conf-pvst)#
FTOS(conf-pvst)#show config
!
protocol spanning-tree pvst
PortID Prio
Role PortID
Desg 128.140 128
Dis 128.142 128
– enter SPANNING TREE mode on the switch.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
no disable
Cost Sts Cost Bridge ID
200000 FWD 0 32773 0001.e832.73f7
200000 DIS 0 32773 0001.e832.73f7
Prio Cost Sts Cost Link-type Edge
200000 FWD 0
200000 DIS 0
PortID
P2P No
P2P No
1289