interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
C-Series, E-Series, S-Series, Z-Series
Syntax
interface range macro name
Parameters
name
Defaults
none
Command Modes
CONFIGURATION
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.0
Example (Single
This example shows the macro named
Range)
FTOS(config)#interface range macro test
FTOS(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
FTOS
Related
interface range
Commands
interface range macro (define)
interface vlan
Configure a VLAN. You can configure up to 4096 VLANs.
Z-Series, S4810, and MXL Switch
Syntax
interface vlan vlan-id [of-instance{of-id}]
Parameters
vlan-id
of-instance{
Defaults
Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes
CONFIGURATION
Enter the name of an existing macro.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
test that was defined earlier.
– configures a range of command (bulk configuration).
– defines a macro for an interface range (bulk configuration).
Enter a number as the VLAN Identifier. The range is 1 to 4096.
of-id }
Enter the keyword of-instance followed by the OpenFlow instance ID
to add the VLAN to the specified OpenFlow instance. Range is 1 to 8.
NOTE: You must associate the OpenFlow instance with the VLAN
when the VLAN is created. An existing VLAN cannot be
associated with an OpenFlow instance.
775