Disable; Forward-Delay - Dell Force10 S4810P Reference Manual

disable

Disable the spanning tree protocol globally on the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax disable
To enable Spanning Tree Protocol, use the no disable command.
Defaults Enabled (that is, the spanning tree protocol is disabled.)
Command Modes SPANNING TREE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Related protocol spanning-tree
Commands

forward-delay

The amount of time the interface waits in the Listening state and the Learning state before transitioning to the
Forwarding state.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
seconds
Defaults 15 seconds
Command Modes SPANNING TREE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
1542
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enters SPANNING TREE mode on the switch.
Enter the number of seconds the FTOS waits before transitioning STP
to the Forwarding state. The range is 4 to 30. The default is 15
seconds.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.