Debug Lacp - Dell Force10 S4810P Reference Manual

debug lacp

Debug LACP (configuration, events, etc.)
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax debug lacp [config | events | pdu [in | out | [interface [in |
out]]]]
To disable LACP debugging, use the no debug lacp [config | events | pdu
[in | out | [interface [in | out]]]] command.
Parameters
config
events
pdu in | out
interface in | out
Defaults none
Command Modes
Command History
Version 8.3.11.1
1020
(OPTIONAL) Enter the keyword config to debug the LACP
configuration.
(OPTIONAL) Enter the keyword events to debug the LACP event
information.
(OPTIONAL) Enter the keyword pdu to debug the LACP Protocol Data
Unit information. Optionally, enter an in or out parameter to:
•
•
(OPTIONAL) Enter the following keywords and slot/port or number
information:
•
•
•
•
•
Optionally, enter an in or out parameter:
•
•
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Receive enter in
Transmit enter out
For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a SONET interface, enter the keyword sonet followed by
the slot/port information.
For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
Receive enter in
Transmit enter out