Ntp Authenticate; Ntp Authentication-Key - Dell Force10 S4810P Reference Manual

ntp authenticate

Enable authentication of NTP traffic between the switch and the NTP time serving hosts.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ntp authenticate
To disable NTP authentication, use the no ntp authentication command.
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage You also must configure an authentication key for NTP traffic using the ntp
Information authentication-key command.
Related

ntp authentication-key

Commands
ntp trusted-key
ntp authentication-key
Specify a key for authenticating the NTP server.
C-Series, E-Series, S-Series, Z-Series
Syntax ntp authentication-key number md5 [0 | 7] key
Parameters
number
md5
0
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– configures the authentication key for NTP traffic.
– configures a key to authenticate.
Specify a number for the authentication key. The range is 1 to
4294967295.
This number must be the same as the number parameter configured
in the ntp trusted-key command.
Specify that the authentication key is encrypted using MD5
encryption algorithm.
Specify that authentication key is entered in an unencrypted format
(default).
1561