Area Stub - Dell Force10 S4810P Reference Manual

To disable route summarization, use the no area area-id range ip-address
mask command.
Parameters
area-id
ip-address
mask
not-advertise
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage Only the routes within an area are summarized, and that summary is advertised to other areas
Information by the ABR. External routes are not summarized.
Related

area stub

Commands
router ospf
area stub
Configure a stub area, which is an area not connected to other areas.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax area area-id stub [no-summary]
To delete a stub area, use the no area area-id stub command.
Parameters
area-id
no-summary
Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a
number from zero (0) to 65535.
Specify an IP address in dotted decimal format.
Specify a mask for the destination prefix. Enter the full mask (for
example, 255.255.255.0).
(OPTIONAL) Enter the keywords not-advertise to set the status
to DoNotAdvertise (that is, the Type 3 summary-LSA is suppressed
and the component networks remain hidden from other areas.)
Introduced on the Z9000.
Introduced on the S4810.
Added support for the Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– creates a stub area.
– enters ROUTER OSPF mode to configure an OSPF instance.
Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a
number from zero (0) to 65535.
(OPTIONAL) Enter the keywords no-summary to prevent the ABR
from sending summary Link State Advertisements (LSAs) into the stub
area.
1145