Ipv6 Pim Dr-Priority - Dell Force10 S4810P Reference Manual

hash-mask-
length
priority
Defaults Refer to Parameters.
Command Modes CONFIGURATION
Command History
Version 8.3.12.0
Version 7.4.1.0

ipv6 pim dr-priority

Change the designated router (DR) priority for the IPv6 interface.
E-Series, S4810
Syntax ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority
command.
Parameters
priority-value
Defaults 1
Command Modes INTERFACE
Command History
Version 8.3.12.0
Version 7.4.1.0
Usage The router with the largest value assigned to an interface becomes the designated router. If
Information two interfaces contain the same designated router priority value, the interface with the largest
interface IP address becomes the designated router.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the E-Series, the range
is 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
(OPTIONAL) Enter the hash mask length for RP selection. The range is
0 to 128. The default is 126.
(OPTIONAL) Enter the priority value for Bootstrap election process.
The range is 0 to 255. The default is 0.
Introduced on the S4810.
Introduced
Enter a number. Preference is given to larger/higher number. The
range is 0 to 4294967294. The default is 1.
Introduced on the S4810.
Introduced
1259