Debug Ip Ospf - Dell Force10 S4810P Reference Manual

Related show ip ospf statistics
Commands

debug ip ospf

Display debug information on OSPF. Entering the debug ip ospf commands enables OSPF debugging for the first
OSPF process.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax debug ip ospf process-id [bfd |event | packet | spf | database-
timer rate-limit]
To cancel the debug command, use the no debug ip ospf command.
Parameters
process-id
bfd
event
packet
spf
database-timer
rate-limit
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.8.0
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage The following describes the debug ip ospf command shown in the Example below.
Information
Field
8:14
1150
– displays the OSPF statistics.
Enter the OSPF Process ID to clear a specific process. If no Process
ID is entered, all OSPF processes are cleared.
(OPTIONAL) Enter the keyword bfd to debug only OSPF BFD
information.
(OPTIONAL) Enter the keyword event to debug only OSPF event
information.
(OPTIONAL) Enter the keyword packet to debug only OSPF packet
information.
(OPTIONAL) Enter the keyword spf to display the Shortest Path First
information.
(OPTIONAL) Enter the keywords database-timer rate-
limit to display the LSA throttling timer information. This applies to
the S4810 platform only.
Introduced on the Z9000.
Added the database-timer rate-limit option for the S4810.
Introduced on the S4810.
Added support for the Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the time stamp.