Mode; Multiplier - Dell Force10 S4810P Reference Manual

mode

Set LLDP to receive or transmit.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx
rx
Defaults Both transmit and receive.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Related
protocol lldp (Configuration)
Commands
show lldp neighbors

multiplier

Set the number of consecutive misses before LLDP declares the interface dead.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer
Defaults 4 x hello
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
1074
Enter the keyword tx to set the mode to transmit.
Enter the keyword rx to set the mode to receive.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enables LLDP globally.
– displays the LLDP neighbors.
Enter the number of consecutive misses before the LLDP declares the
interface dead. The range is 2 to 10.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
interface -lldp)
interface -lldp)