Ip Udp-Broadcast-Address - Dell Force10 S4810P Reference Manual

Command History
Version 8.3.7.0
Pre-version
8.3.7.0
Example
FTOS#debug ip udp-helper
UDP helper debugging is on
01:20:22: Pkt rcvd on Gi 5/0 with IP DA (0xffffffff) will be
sent on Gi 5/1 Gi 5/2
Vlan 3
01:44:54: Pkt rcvd on Gi 7/0 is handed over for DHCP
processing.
Related

ip udp-broadcast-address

Commands
ip udp-helper udp-port
show ip udp-helper
ip udp-broadcast-address
Configure an IP UDP address for broadcast.
E-Series, S4810
Syntax ip udp-broadcast-address address
To delete the configuration, use the no ip udp-broadcast-address address
command.
Parameters
address
Defaults Not configured.
Command Modes INTERFACE (config-if)
Command History
Version 8.3.7.0
Pre-version
8.3.7.0
Usage When a UDP broadcast packet is flooded out of an interface, and the outgoing interface is
Information configured using this command, the outgoing packet's IP destination address is replaced with
the configured broadcast address.
Related
debug ip udp-helper
Commands
show ip udp-helper
832
Introduced on the S4810.
Introduced on the E-Series ExaScale.
– configures a UDP IP address for broadcast.
– enables the UDP broadcast feature on an interface.
– displays the configured UDP helper(s) on all interfaces.
Enter an IP broadcast address in dotted decimal format (A.B.C.D).
Introduced on the S4810.
Introduced on the E-Series ExaScale.
– enables debug and displays the debug information on a console.
– displays the configured UDP helper(s) on all interfaces.