Protocol Spanning-Tree Rstp - Dell Force10 S4810P Reference Manual

To return to the default values, use the no max-age command.
Parameters
max-age
Defaults 20 seconds
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.1
Related
forward-delay
Commands
hello-time

protocol spanning-tree rstp

Enter RSTP mode to configure RSTP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not configured
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.1
Usage RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use
Information the no disable command from RSTP mode.
Example
FTOS(conf)#protocol spanning-tree rstp
FTOS(config-rstp)##no disable
1396
Enter a number of seconds the FTOS waits before refreshing
configuration information. The range is 6 to 40 seconds. The default is
20 seconds.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– changes the wait time before RSTP transitions to the Forwarding state.
– changes the time interval between BPDUs.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.