After the OSPF process and the VRF are tied together, you cannot use the OSPF Process ID
again in the system.
Example
FTOS(conf)#router ospf 2
FTOS(conf-router_ospf)#
show config
Display the non-default values in the current OSPF configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes
ROUTER OSPF
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Example
FTOS(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
FTOS(conf-router_ospf)#
show ip ospf
Display information on the OSPF process configured on the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip ospf process-id [vrf vrf name]
Parameters
process-id
vrf name
Command Modes
Command History
Version 8.3.11.1
1178
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
E-Series Only: Show only the OSPF information tied to the VRF
process.
•
EXEC
•
EXEC Privilege
Introduced on the Z9000.