Show Range; Show Running-Config Ecmp-Group - Dell Force10 S4810P Reference Manual

show ip interface
show interfaces
show inventory (C-Series and E-Series)
media), FTOS version including hardware identification numbers and configured protocols.
show inventory (S-Series)
FTOS version including hardware identification numbers and configured protocols.

show range

Display all interfaces configured using the interface range command.
C-Series, E-Series, S-Series, Z-Series
Syntax show range
Command Modes INTERFACE RANGE (config-if-range)
Command History
Version 8.3.11.1
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.1.1.0
Example
FTOS(conf-if-range-so-2/0-1,fa-0/0)#show range
interface sonet 2/0 - 1
interface fastethernet 0/0
FTOS(conf-if-range-so-2/0-1,fa-0/0)#
Related
interface
Commands
show ip interface
show interfaces

show running-config ecmp-group

Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution using the ecmp-group
monitoring enable command. The ECMP group could have a LAG or a list of 10G/40 interfaces (not just LAG link-
bundles).
S4810
Syntax show running-config ecmp-group
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.10.0
812
– displays Layer 3 information about the interfaces.
– displays information on a specific physical interface or virtual interface.
– displays the S-Series switch type, components (including media),
Introduced on the Z9000.
Added support for 4093 VLANs on E-Series ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
– configures a physical interface on the switch.
– displays Layer 3 information about the interfaces.
– displays information on a specific physical interface or virtual interface.
Introduced on the S4810.
– displays the chassis type, components (including