Distribute-List Out - Dell Force10 S4810P Reference Manual

Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Related ip prefix-list
Commands

distribute-list out

Configure a filter for outgoing routing updates.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax distribute-list prefix-list-name out [interface | bgp |
connected | isis | ospf | static]
To delete the filter, use the no distribute-list prefix-list-name out
command.
Parameters
prefix-list-name
interface
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enters PREFIX-LIST mode and configures a prefix list.
Enter the name of a configured prefix list.
(OPTIONAL) Identifies the interface type slot/port as one of the
following:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
1359