Pim-Sparse Mode (Pim-Sm); Ipv4 Pim-Sparse Mode Commands; Clear Ip Pim Rp-Mapping; Clear Ip Pim Tib - Dell Force10 S4810P Reference Manual

PIM-Sparse Mode (PIM-SM)

The protocol-independent multicast (PIM) commands are supported by the Dell Force10 operating software (FTOS) on all
E-Series, C-Series, S-Series, Z-Series, or S4810 platforms.

IPv4 PIM-Sparse Mode Commands

The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.

clear ip pim rp-mapping

Used by the bootstrap router (BSR) to remove all or particular rendezvous point (RP) advertisement.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax clear ip pim rp-mapping rp-address
Parameters
rp-address
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0

clear ip pim tib

Clear PIM tree information from the PIM database.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax clear ip pim tib [group]
Parameters
group
Command Modes EXEC Privilege
(OPTIONAL) Enter the RP address in dotted decimal format (A.B.C.D).
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
(OPTIONAL) Enter the multicast group address in dotted decimal
format (A.B.C.D).
38
1235