Set - Dell Force10 S4810P Reference Manual

qos-policy
policy-name
Defaults none
Command Modes CONFIGURATION (conf-policy-map-in and conf-policy-map-out)
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage There are eight (8) queues per interface on the E-Series and four (4) queues per interface on
Information the C-Series and S-Series. This command assigns a class map or QoS policy to different
queues.
Related
class-map
Commands
service-policy input
service-policy output

set

Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax set {ip-dscp value | mac-dot1p value}
Parameters
ip-dscp
mac-dot1p
Defaults none
Command Modes CONFIGURATION (conf-qos-policy-in)
Command History
Version 8.3.11.1
Version 8.3.7.0
1332
NOTE: This option is available under policy-map-input only.
qos-
(OPTIONAL) Enter the keywords qos-policy followed by the QoS
policy name assigned to the queue in text format (16 characters
maximum). This specifies the input QoS policy assigned to the queue
under policy-map-input and output QoS policy under
policy-map-output context.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– identifies the class map.
– applies an input policy map to the selected interface.
– applies an output policy map to the selected interface.
value
(OPTIONAL) Enter the keywords ip-dscp followed by the IP DSCP
value. The range is 0 to 63.
value
Enter the keywords mac-dot1p followed by the dot1p value. The
range is 0 to 7. On the C-Series and S-Series, the allowed values are:
0, 2, 4, 6.
Introduced on the Z9000.
Introduced on the S4810.