Show Ip Mroute - Dell C9000 Series Reference Manual

Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.1
E-Series legacy
command
Usage Information After you enable multicast, you can enable IGMP and PIM on an interface. In
INTERFACE mode, enter the ip pim sparse-mode command to enable IGMP and
PIM on the interface.
Related ip pim sparse-mode
Commands

show ip mroute

View the multicast routing table.
C9000 Series
Syntax
show ip mroute [static | group-address [source-address] | count |
snooping [vlan vlan-id] [group-address [source-address]] | summary
| vlt [group-address [source-address] | count]
Parameters
static
group-address
[source-address]
count
Description
Introduced on the C9010.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— enables IGMP and PIM on an interface.
(OPTIONAL) Enter the keyword static to view static multicast
routes.
(OPTIONAL) Enter the multicast group-address to view only
routes associated with that group. Enter the source-address to
view routes with that group-address and source-address.
(OPTIONAL) Enter the keyword count to view the number of
multicast routes and packets.
Multicast 1397