Delay-Restore; Lacp Ungroup Member-Independent - Dell Force10 S4810P Reference Manual

delay-restore

Configure the delay in bringing up VLT ports after reload or peer-link restoration between the VLT peer switches.
Z-Series, S4810
Syntax delay-restore
Parameters
delay-restore
Defaults Not configured.
Command Modes VLT DOMAIN
Command History
Version 9.0.0.0
Version 8.3.12.0
Usage Use the delay-restore parameter to delay the system from bringing up the VLT port for a
Information
brief period to allow IGMP Snooping and Layer 3 routing protocols to converge. Use this
feature:
Related show vlt statistics
Commands

lacp ungroup member-independent

Prevent possible loop during the bootup of a VLT peer switch or a device that accesses the VLT domain.
Z-Series, S4810
Syntax lacp ungroup member-independent {vlt | port-channel}
Parameters
port-channel
vlt
Example
FTOS (conf)#lacp ungroup member-independent ?
port-channel
switchports
Enter the amount of time, in seconds, to delay bringing up the VLT
ports after the VLTi device is reloaded or after the peer-link is
restored between VLT peer switches. The range 1 to 1200. The default
is 90 seconds.
Introduced on the Z9000.
Introduced on the S4810.
• after a VLT device is reloaded.
• if the Peer VLT device was up at the time the VLTi link failed to the time when it was
restored.
– displays statistics on VLT operations.
Force all LACP port-channel members to become switchports.
Force all VLT LACP members to become switchports.
LACP port-channel members become
1601