Distribute-List In - Dell Force10 S4810P Reference Manual

distribute-list in

Apply a filter to incoming routing updates from OSPF to the routing table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax distribute-list prefix-list-name in [interface]
To delete a filter, use the no distribute-list prefix-list-name in
[interface] command.
Parameters
prefix-list-name
interface
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
1156
Enter the name of a configured prefix list.
(OPTIONAL) Enter one of the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Port Channel groups, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
32 for EtherScale and 1 to 255 for TeraScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
Introduced on the Z9000.
Introduced on the S4810.
Added support for the Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.