Default-Metric - Dell Force10 S4810P Reference Manual

metric
value
route-map
name
Defaults Disabled. Metric: 1.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage The default route must be present in the switch routing table for the default-
Information information originate command to take effect.

default-metric

Change the default metric for routes. Use this command with the redistribute command to ensure that all
redistributed routes use the same metric value.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax default-metric number
To return the default metric to the original values, use the no default-metric command.
Parameters
number
Defaults 1
Command Modes ROUTER RIP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
1356
metric-
(OPTIONAL) Enter the keyword metric followed by a number as the
metric value. The range is 1 to 16. The default is 1.
map- (OPTIONAL) Enter the keywords route-map followed by the name
of a configured route-map.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Specify a number. The range is 1 to 16. The default is 1.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.