Dei Mark; Member - Dell Force10 S4810P Reference Manual

dei mark

Set the DEI value on egress according to the color currently assigned to the packet.
C-Series, S-Series, Z-Series, S4810
Syntax dei mark {green | yellow} {0 | 1}
Parameters
0 | 1
green | red |
yellow
Defaults All the packets on egress are marked with DEI 0.
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Usage You must first enable DEI for this configuration to take effect.
Information
Related dei enable
Commands

member

Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible
command in its configuration.
C-Series, E-Series, S-Series, Z-Series
Syntax member interface
To remove an interface from a Stackable VLAN, use the no member interface
command.
Parameters
interface
Enter the bit value you want to map to a color.
Choose a color:
• Green: High priority packets that are the least preferred to
be dropped.
• Yellow: Lower priority packets that are treated as best-
effort.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
– enables DEI.
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
1589