Ipv6 Access-List; Ipv6 Control-Plane Egress-Filter - Dell Force10 S4810P Reference Manual

ipv6 access-list

Configure an access list based on IPv6 addresses or protocols.
C-Series, E-Series, S-Series, S4810
Syntax ipv6 access-list access-list-name
To delete an access list, use the no ipv6 access-list access-list-name
command.
Parameters
access-list-name
Defaults All access lists contain an implicit "deny any"; that is, if no match occurs, the packet is
dropped.
Command Modes CONFIGURATION
Command History
Version 8.3.7.0
Version 8.4.2.1
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
Usage The number of entries allowed per ACL is hardware-dependent. For detailed specification on
Information entries allowed per ACL, refer to your line card documentation.
Related show config
Commands

ipv6 control-plane egress-filter

Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
C-Series, E-Series, S-Series, S4810, Z9000
Syntax ipv6 control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Command History
Version 9.0.0.0
Version 8.3.10.0
912
Enter the as the access list name as a string, up to 140 characters.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
Introduced on the C-Series. Increased the name string to accept up
to 140 characters. Prior to version 7.8.1.0, names are up to 16
characters long.
Introduced on the E-Series TeraScale.
– views the current configuration.
Introduced on the Z9000.
Introduced on the S4810.