Mib-Binding - Dell Force10 S4810P Reference Manual

To disable packet forwarding over multiple paths, use the no maximum-paths command.
Parameters
number
Defaults 4
Command Modes ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command History
Version 9.1(0.0)
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1

mib-binding

Enable this OSPF process ID to manage the SNMP traps and process SNMP queries.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax mib-binding
To mib-binding on this OSPF process, use the no mib-binding command.
Defaults none.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Usage
This command is either enabled or disabled. If no OSPF process is identified as the MIB
Information
manager, the first OSPF process is used.
If an OSPF process has been selected, it must be disabled prior to assigning new process ID
the MIB responsibility.
1170
Specify the number of paths. The range for OSPFv2 is 1 to 16. The
default for OSPFv2 is 4 paths. The range for OSPFv3 is 1 to 64. The
default for OSPFv3 is 8 paths.
Introduced support for OSPFv3 on the S4810 and the Z9000.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Introduced on the Z9000.
Introduced on the S4810.
Introduced to all platforms.