Ip Pim Dr-Priority - Dell Force10 S4810P Reference Manual

hash-mask-
length
priority
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 6.1.1.0

ip pim dr-priority

Change the designated router (DR) priority for the interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority command.
Parameters
priority-value
Defaults 1
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Usage The router with the largest value assigned to an interface becomes the designated router. If
Information two interfaces contain the same designated router priority value, the interface with the largest
interface IP address becomes the designated router.
1238
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
(OPTIONAL) Enter the hash mask length. The range is zero (0) to 32.
The default is 30.
(OPTIONAL) Enter the priority used in Bootstrap election process. The
range is zero (0) to 255. The default is zero (0).
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Added support for the VLAN interface.
Enter a number. Preference is given to larger/higher number. The
range is 0 to 4294967294. The default is 1.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series on port-channels and the S-Series.