Multicast; Ipv4 Multicast Commands; Clear Ip Mroute - Dell Force10 S4810P Reference Manual

Multicast

The multicast commands are supported by FTOS on all E-Series, C-Series, S-Series, Z-Series, or S4810 Dell Force10
platforms.
This chapter contains the following sections:
•

IPv4 Multicast Commands

• IPv6 Multicast Commands
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.

clear ip mroute

Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree
information base, use the clear ip pim tib command.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax clear ip mroute {group-address [source-address] | *}
Parameters
group-address
source-address ]
[
*
Command Modes EXEC Privilege
Command History
Version 8.3.7.0
Version 7.8.1.0
E-Series legacy
command
Related show ip pim tib
Commands
Enter the multicast group address and source address (if desired), in
dotted decimal format, to clear information on a specific group.
Enter * to clear all multicast routes.
Introduced on the S4810.
Introduced on the C-Series.
– shows the PIM tree information base.
35
1117