Vrrp-Group; Ipv6 Vrrp Commands - Dell Force10 S4810P Reference Manual

vrrp-group

Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax vrrp-group vrrp-id
Parameters
vrrp-id
Defaults Not configured.
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage The VRRP group only becomes active and sends VRRP packets when a virtual IP address is
Information configured. When you delete the virtual address, the VRRP group stops sending VRRP packets.
Related virtual-address
Command

IPv6 VRRP Commands

The following are IPv6 VRRP commands.
• clear counters vrrp ipv6
• debug vrrp ipv6
• show vrrp ipv6
• vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
• advertise-interval
• description
• disable
• hold-time
• preempt
• priority
• show config
1626
Enter a number as the group ID. The range is 1 to 255.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– assigns up to 12 virtual IP addresses per VRRP group.