Snmp Trap Link-Status; Syslog Commands - Dell Force10 S4810P Reference Manual

Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage The oid-tree variable is a full sub-tree starting from 1.3.6 and can not specify the name of a
Information sub-tree or a MIB. The following Example configures a view named
all objects under 1.3.6.1.
Example
FTOS# conf
FTOS#(conf) snmp-server view rview 1.3.6.1 included
Related show running-config
Commands

snmp trap link-status

Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
C-Series, E-Series, S-Series, Z-Series
Syntax snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status command.
Defaults Enabled.
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage If the interface is expected to flap during normal usage, you could disable this command.
Information

Syslog Commands

The following commands allow you to configure logging functions on all Dell Force10 switches.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
snmp – displays the SNMP running configuration.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
rview that allows access to
1497