Show Tdr - Dell Force10 S4810P Reference Manual

Command History
Version 8.3.7.0
Version 8.2.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.1.1.0
Usage
The interface must be enabled to run the test or an error message is generated:
Information
FTOS#tdr-cable-test gigabitethernet 5/2
%Error: Interface is disabled GI 5/2
The C-Series and S-Series do not generate log messages is generated when the link flaps
down/up during TDR tests. The E-series, does produce these log messages.
Related

show tdr

Commands
show tdr
Display the TDR test results.
C-Series, E-Series, S-Series, S4810
Syntax show tdr interface
Parameters
interface
Defaults none
Command Modes EXEC
Command History
Version 8.3.7.0
Version 8.2.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.1.1.0
Usage If the TDR test has not been run, an error messages is generated:
Information
%Error: Please run the TDR test first
The following describes the TDR test status.
Status
OK Status:
Terminated
830
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– displays the results of the TDR test.
Enter the keyword GigabitEthernet followed by the slot/port
information for the 100/1000 Ethernet interface.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
Definition
TDR test is complete, no fault is detected on the cable, and the test is
terminated.