Ip Pim Register-Filter; Ip Pim Rp-Address - Dell Force10 S4810P Reference Manual

Version 8.1.1.0
Version 7.8.1.0

ip pim register-filter

Use this feature to prevent a PIM source DR from sending register packets to an RP for the specified multicast source
and group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip pim register-filter access-list
To return to the default, use the no ip pim register-filter access-list
command.
Parameters
access-list
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Usage The access name is an extended IP access list that denies PIM register packets to RP at the
Information source DR based on the multicast and group addresses. Do not enter this command before
creating the access-list.

ip pim rp-address

Configure a static PIM rendezvous point (RP) address for a group or access-list.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip pim rp-address address {group-address group-address mask}
override
To remove an RP address, use the no ip pim rp-address address {group-
address group-address mask} override command.
Parameters
address
group-address
group-address
mask
1242
Introduced on the E-Series ExaScale.
Introduced on the C-Series for the port-channels and the S-Series.
Enter the name of an extended access list. Maximum 16 characters.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced
Enter the RP address in dotted decimal format (A.B.C.D).
Enter the keywords group-address followed by a group-address
mask, in dotted decimal format (/xx), to assign that group address to
the RP.