Dell Force10 S4810P Reference Manual page 791

Line
Output Statistics:
Rate information...
Time since...
Example
FTOS#show interfaces
TenGigabitEthernet 2/0 is down, line protocol is down
Hardware is DellForce10Eth, address is 00:01:e8:8b:3d:e7
Current address is 00:01:e8:8b:3d:e7
Pluggable media present, Media type is unknown
Wavelength unknown
Interface index is 100992002
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 3d17h53m
Queueing strategy: fifo
Input Statistics:
pkts
Description
Displays output statistics sent out of the interface including:
•
•
•
•
Estimate of the input and output traffic rate over a designated
interval (30 to 299 seconds). Traffic rate is displayed in bits, packets
per second, and percent of line rate.
Elapsed time since the last interface status change (hh:mm:ss
format).
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
– CRC = packets with CRC/FCS errors
– overrun = number of packets discarded due to FIFO
overrun conditions
– discarded = the sum of runts, giants, CRC, and
overrun packets discarded without any processing
Number of packets, bytes, and underruns out of the interface
Packet size and the number of those packets outbound to
the interface
Number of Multicast, Broadcast, and Unicast packets:
– Multicasts = number of MAC multicast packets
– Broadcasts = number of MAC broadcast packets
– Unicasts = number of MAC unicast packets
Number of VLANs, throttles, discards, and collisions::
– Vlans = number of VLAN tagged packets
– throttles = packets containing PAUSE frames
– discarded = number of packets discarded without
any processing
– collisions = number of packet collisions
– wred=count both packets discarded in the MAC and
in the hardware-based queues
791