Track Ip - Dell Force10 S4810P Reference Manual

pre-Version
6.2.1.1
Usage
When you use the no tagged command, the interface is automatically placed in the Default
Information
VLAN as an untagged interface unless the interface is a member of another VLAN. If the
interface belongs to several VLANs, you must remove it from all VLANs to change it to an
untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can only belong to
one VLAN at a time.
Related
interface vlan
Commands
untagged

track ip

Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member interfaces.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax track ip interface
To remove the tracking feature from the VLAN, use the no track ip interface
command.
Parameters
interface
Defaults Not configured.
Command Modes INTERFACE VLAN
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Introduced on the E-Series.
– configures a VLAN.
– specifies which interfaces in a VLAN are untagged.
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
1057